![]() The initial electric field and therefore the bias voltage, the time delay between subsequent pulses and the amount of initially created charge have a large impact on this phenomenon. The polarization mechanisms happening in the sensor are described by a theoretical model and additionally supported by simulations. The decrease can be explained by polarization, which is caused by trapped charges and is well known in larger band-gap materials like diamond, but often neglected for silicon at this relatively high temperature. A decrease of signal pulse amplitude, which originates from effects of the flowing charges on the electric field configuration, is observed using irradiated diodes measured with top-TCT. In this paper, the investigation of the effects due to previously created charge in subsequent pulse detection is investigated. In previous studies it was observed that the detection of subsequent signals separated up to several microseconds is altered by the charge trapped during the proceeding pulses. The signal formation was studied in silicon strip sensors, which have been irradiated and annealed until the phenomenon of charge multiplication occurred. Silicon has proven to be extremely radiation hard, sufficient signals can be recorded at fluences above 1 × 1 0 16 n eq / cm 2. ![]() Upcoming high energy physics experiments like the High-Luminosity LHC require unprecedented radiation hardness of the detectors, as well as short readout time due to high luminosity and occupancy.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |